Wycotool Hydraulic Paving Vibrators User Manual

Operation andService ManualforWYCOHydraulic PavingVibrators

AGLE HYDRAULIC VIBRATOR ASSEMBLY - 949-170FIGURE 1. *Male and female quick disconnects may be on either the pressure or return line. Always check tha

9

10HYDRAULIC VIBRATOR ASSEMBLY PARTS LISTPART UMBERITEM QTY U/M DESCRIPTIO STRAIGHT949-100AGLE949-1701 1 EA SQUARE Head Housing with Lower Bearing

11Wyco Tool CompanyCHAPTER 4 SERVICE AD ASSEMBLY ISTRUCTIOSa) Maintenance intervalIt is recommended that Wyco vibrators be maintained at regular in

12Wyco Tool Company3) Rotor Disassembly Clamp the rib of rotor (6) in a vise. Unscrew the driver sleeve (9) (left hand thread). Remove the spacer (

13Wyco Tool CompanySlide another bearing onto the rotor with the writing on the outer race facing away from therotor and the other bearing.Slide a was

1414Wyco Tool CompanyOnce the rotor is engaged to the motor housing, slide the head housing over the rotor and begin to engage the threads.Apply No. 2

15Wyco Tool Company15Seals1) Seal RemovalIt may be possible to remove the hydraulic motor seal assembly without removing the hydraulic motor from the

16Wyco Tool Companye) Hose, Hydraulic Motor and Alternate Hydraulic Motor Seal Removal1) Protective hose removalLoosen or remove the hose clamp

17Wyco Tool Companymotor between the jaws of a large crescent or pipe wrench and rotate the motor in either direction to break the silicone sealant th

CHAPTER 1 - GEERAL IFORMATIO ...

1818Wyco Tool CompanyInstall the protective hose (27) completely onto the hose barb of the angle bracket. Position the Punch Lock Clamp (26) over the

19

20

21

22

23Wyco Tool Company8635 Washington AvenueRacine, WI 53406T: (262) 639-6770 or (800) 233-9926F: (262) 639-2023 or (888) 992-6872E-mail: wycosales@wycot

1CHAPTER 1GEERAL IFORMATIOa) Purpose of VibrationThe use of internal vibration is required to improve the workability of low slump con-crete used i

2Wyco Tool Company CHAPTER 2 VIBRATOR DESIG FUDAMETALSa) RotorThe rotor is the component that generates vibration. A vibration impulse is generat

3The quick disconnects can be attached to eachother when removed from the machine to prevent contamination.h) Protective Hoses and PlugsA rubber pr

4CHAPTER 3 ISTALLATIO AD OPERATIGREQUIREMETSa) Mounting VibratorsSee figure line art drawings for illustrations ofitem numbers listed in parenthe

5the most. The rule then can be read giving the operating speed.Wyco Tool CompanyCOULD CAUSE SERIOUS DAMAGE. WHE EXCESSIVE TEMPERATURES ARE ECOUTE

TROUBLE SHOOTIG CHARTWyco Tool CompanyTrouble Possible Causes SolutionsVibrator not running 1) Required oil flow and pressure not supplied 1) Supply

STRAIGHT HYDRAULIC VIBRATOR ASSEMBLY - 949-100FIGURE 1. *Male and female quick disconnects may be on either the pressure or return line. Always check